Fixture Setup - Martin MiniMAC Maestro User Manual

number on each fixture can all be triggered to start simultaneously by a master
fixture. This is further explained in the section "About scene timing" on page 29.
F I X T U R E S E T U P
Important: The IR mode address is different from the DMX mode address
and can only be set after rCS or rCr has been selected.
To setup multiple fixtures for DMX Stand-Alon e operation
1 Plug a data cable into the OUT socket of the first fixture and the IN socket of the next
fixture. Repeat as required to connect up to 32 fixtures.
2 Insert a male termination plug (P/N 91613017) into the OUT socket of the last fixture.
If you experience random "flicker" or other unexplained control problems, insert a
female termination plug (P/N 91613018) into the IN socket of the first fixture.
3 Set all fixtures to DMX mode 4. From the control panel, scroll to
menu, press [enter]. Select
is not required.
4 Using the run options under the control menu set the execution settings of the
respective fixtures to run as slaves, or as the master (only one fixture on the link may
be the master). See "Execution commands" on page 32.
5 (Optional) Set the personality options described on page 19.
6 Study "About scene timing" on page 29, ensuring that you understand it and then use
the menus to program scenes into each fixture. See "Menu commands" on page 30.
To setup on e fixt ure for IR Stan d-Alone op eration
1 Insert the receiver module into the serial data In socket. Position the sensor arm as
desired but avoid turning it more than necessary.
2 Scroll to
Press [enter].
3 Select
and press [enter].
4 Stand 2 meters (6 ft.) away from the fixture, point the remote control at the receiver,
and press the lamp power button. If there is no response, try the ID button. If there is
still no response, reverse the sensor head by rotating the sensor arm 180° and folding
it over.
5 (Optional) Set the gobo blackout, display, and automatic lamp-on personality options
as described on page 19.
d 4
P ro
in the control panel main menu, press [enter], and scroll to
A dr
from the main menu and press [enter]. Select an address from 0 to 9
Stand-alone operation
. Press [enter] to activate the setting. Address setting
Pr o
in the main
r C S
.
27