Basic Service; Cleaning - Martin MiniMAC Maestro User Manual

B
ASIC SERVICE
The MiniMAC Maestro requires simple routine maintenance. The schedule depends
heavily on the operating environment; please consult a Martin service technician for
recommendations.
Refer all service not described here to a qualified Martin technician.
Important! Excessive dust, grease, and smoke fluid buildup degrades
performance and causes overheating and damage to the fixture
that is not covered by the warranty.
Warning! Disconnect the fixture from power before removing any cover.
C L E A N I N G
To op en the head
1 Disconnect the fixture from power and allow it to cool. Unlock the head cover
fasteners by turning them a quarter-turn counterclockwise. Open the rear cover by
pulling from the ribbed end.
2 Pull off the top head cover.
3 When replacing the cover, turn the fasteners a half to a quarter turn clockwise until
they click. Do not overtighten.
To clean op tical compon ents
Use care when cleaning optical components. The surfaces are fragile and small
scratches may be visible.
1 Disconnect the fixture from power and allow it to cool. Remove the head cover.
2 Blow or vacuum away loose dust. Remove residues from lenses with a soft cloth or
cotton swabs wetted with isopropyl alcohol. Regular glass cleaner may also be used,
but no residues may remain.
3 Rinse with distilled water. Mixing the water with a small amount of wetting agent such
as Kodak Photoflo will help prevent streaking and spotting.
4 Dry with a clean, soft and lint-free cloth or blow dry with compressed air.
42

Basic service

9