Adjusting The Shoulder Pad Position; Mounting The Camera To A Tripod - Sony HDC2500 Operation Manual

3
Secure the cable clamp belt to the camera, using the
two supplied +B3×8 screws.
×
+B3 8 screws
4
1 Release the buckle, 2 bundle the cable with the
belt, 3 then lock the buckle again.
1
Camera cable
5
Adjust the length by pulling down the end of the belt.
22
Preparations
3
2

Adjusting the Shoulder Pad Position

You can shift the shoulder pad from its center position (factory
setting) backward by up to 10 mm (3/8 inch) or forward by up
to 25 mm (1 inch). This adjustment helps you get the best
balance for shooting with the camera on your shoulder.
Adjusting procedure
Shoulder pad lock lever
Bottom of the camera
1
Raise the lever in the center of the shoulder pad to
unlock the shoulder pad.
2
Slide the shoulder pad backward or forward until it is
in the most convenient position.
3
Move the lever down to lock the shoulder pad in the
selected position.

Mounting the Camera to a Tripod

Mount the camera to a tripod using a VCT-14 Tripod
Attachment.
Caution
• Select an appropriate hole from among those at the bottom
of the tripod attachment considering the balance of the
weight of the camera and the tripod attachment. If an
inappropriate hole is selected, the camera may fall over.
• Check that the size of the selected hole matches that of the
screw of the tripod. If they do not match, the tripod
attachment cannot be attached to the tripod securely.
1,3
2
Shoulder pad