Fire Sense LIP-09A-TGG Instruction Manual page 10

9. Attach Mesh Guards to Supports.
Hint: It is best to begin with bottom pieces of Mesh
Guards.
Locate one Mesh Guard. Slide the Mesh Guard
Connectors up the Support and hold them in the
center of the Support. Then insert the longer tabs at
the bottom of the Mesh Guard into the holes on Tank
Housing/Base. Insert the shorter tabs at the top of the
Mesh Guard into the holes on the Mesh Guard
Connector. Repeat with three more Mesh Guards on
lower row. Attach upper Mesh Guards by inserting
longer tabs at the top of the Mesh Guard through the
holes in Emitter and slide the tabs on the bottom end
of the upper Mesh Guard into holes in the Mesh Guard
Connectors. Then secure the Mesh Guard by inserting
the top rung into the fastener piece pre-assembled on
the Emitter (see Fig A).
Before placing LP tank onto base of heater, attach Cylinder Holder (K)
10.
to base using 3 pieces of M6x12 Bolts.
Hardware Used: 3 x D, M6x12 Bolt
Connect the Regulator/Hose assembly to the LPG cylinder. The LPG cylinder is
sold separately. Use a standard 20 lb. LPG cylinder only. Screw the
Regulator/Hose assembly to the LPG cylinder. Do not cross thread. Hand tighten
securely. Then attach the Regulator/Hose assembly to the end of the hose
that extends from the Burner. Do not cross thread. Hand tighten securely then
tighten with a wrench. Place LPG tank into the Cylinder Holders and tighten the
screws in the Cylinder Holders to secure LPG tank on base.
NOTE: Use this heater only with a propane vapor withdrawal supply system. See chapter 5 of the standard for
storage and handling of liquefied petroleum gas, ANSI/NFPA 58. Your local library or fire department should have
this book.
-
ASSEMBLY
9
Fig. A
10 -
10