Set Mode Setting - Icom IA14 Instruction Manual

6
OTHER FUNCTIONS
n Set mode setting
Set mode is used for programming infrequently changed val-
ues or conditions of functions.
D Entering set mode
q Rotate [VOL] to turn the
transceiver power OFF.
w While pushing and holding
[Y] and [Z], turn [VOL] to
enter set mode.
e Push [MR] several times
to select the desired set
mode item.
r Push [Y]/ [Z] to select the
desired condition or value
for the item.
t Push [CLR] to return to
frequency mode.
For IC-A14 only
Push [FUNC] then push and hold [SET](ENT) for 1 sec. to
also enters into set mode.
For your information:
The default value of the set mode items can be changed
with the optional cloning software, CS-A14. And the de-
fault settings are re-called by the home function.
25
[VOL]
[Y] [MR]
[Z]
[CLR]
D Set mode items
• ANL— ANL function
(available with IC-A14S only)
Sets the ANL
(Automatic Noise Limiter)
noise components such as that caused by engine ignition
systems while receiving.
• BEEP— Key touch beep
The beep tone which sounds at the push of a switch can be
set, if desired.
• MIC— Microphone gain
The internal microphone gain can be selected to suits your
communicating style.
"H" , "M"
(High gain) (Middle gain)
are available.
function that reduces
(available with IC-A14S only)
and "L" selections
(Low gain)