Advertisement
MINIATURE MICROPHONE
HEADBANDS
Adjusting the Type 4065 Headband
The Miniature Headband 4065 is pre-
formed for your convenience. However, it
requires minor adjustment in order to get
a tight, fixed position to the back of the
neck. Carefully bend the steel tube at the
areas shown on the illustration.
Note: Do not bend the steel tube near
the microphone element or near the
cable exit as you may risk breaking the
tube. The microphone element is per-
fectly omnidirectional and does not
need to point directly towards the
mouth of the performer. Avoid posi-
tioning the microphone in the air
stream from nose or mouth.
8
When bending the steel tube please treat
with care. The steel tube must be bent
around a curved object (min. diameter of
20mm) or a thumb in order not to break the
headband.
Do not bend near these parts of the
headband.
Hide quick links:
Advertisement
