USER’S MANUAL Omnidirectional Microphones 4003 Type 4006 Type Included in kit solutions 3529-A Type 3530-A Type CONTENTS Technical Description Full Specifications Care of Microphone Service and Repair Warranty CE Standard...
Preamplifier Supply tion voltage. The preamplifiers Fig. 1. External view of the output socket of the Type 4003. Types 4003 and 4006 are acoustically identical, but differ in their preamplifier powering system. The 4003 is powered with 130V via the HMA4000 High-Voltage Microphone Amplifier and has a modi-...
Page 3
The APEs are pre- cision made from a special compact nylon material and will only fit the Types 4003 and 4006 fitted with the standard Nearfield Grid The Diffuse-field Grid The Diffuse-field Grid DD0297 is supplied as standard. It is DD0251.
Page 4
20 Hz 50 500 1 kHz 40 D A B C Lin. Fig. 3. On-axis and diffuse-field responses of Types 4003 and 4006 Fig. 5. Diffuse-field response of Types 4003 and 4006 with Nose with the Near-field Grid DD0251 fitted.
Page 5
50 kHz 200 Hz 2 kHz 20 kHz Fig. 8. On-axis amplitude and phase responses of Types 4003 and Fig. 10. Typical third-octave inherent-noise spectrum of Type 4006. 4006 plotted using a linear frequency axis for evaluation of the phase response.
Page 6
25 dB 25 dB 5 dB 20 dB On-axis 20 dB 15 dB 15 dB 10 dB 10 dB 5 dB 5 dB 1 kHz 10 12 16 20 5 dB On-axis 1 kHz 10 12 16 20 25 dB 25 dB 20 dB 20 dB...
Page 8
Stereo Boom excluding Holders screens and a compact stereo boom for floor or ceiling mounting. UA0897 Shock Mount The 3529-A uses the DPA preamp included. This allows a complete- UA0639 Microphone Clip ly transformerless signal path and high voltage powering. Both sets...
Windscreen for Ø16mm (0.63in) Microphone 2 x L110C Acoustic Pressure Equaliser, 110mm (4.33in) Cylinder Types 4003 and 4006 are supplied with an additional Diffusefield 2 x L30B Acoustic Pressure Equaliser, 30mm (1.18in) Ball Grid DD0297 (see “Technical Description” and “Full Specifications”).
Page 10
USE OF ACOUSTIC PRESSURE EQUALIZERS Acoustic Pressure Equalizers are only to be used with the standard silver protection grid DD0251. Do not thouch Do not try to fit APEs on Nose Cone UA0777. the diaphragm The microphone must be inserted into the APE from the hole oppo- site to the O-ring.
Please contact DPA Microphones for your nearest representative on Tel: +45 48 14 28 28 Fax: +45 48 14 27 00. You can also get in touch with DPA Microphones via the internet using e-mail info@dpamicrophones.com Visit our website at www.dpamicrophones.com...