Related Manuals for DPA 4011
Summary of Contents for DPA 4011
-
Page 1: Table Of Contents
U S E R’ S MA NUA L Cardioid Microphones 40 1 1 Type 40 12 Type Wide Cardioid Microphones 4015 Type 4016 Type Included in kit solutions: 35 1 1 Type CO N T E N TS Technical Description Full Specifications Care of Microphones Service and Repair... -
Page 2: Technical Description
19mm diameter prepolarized pressure gradient condenser- m i c ro- phone car t r i d ge. Type 4011 and 4012 offer a f i rst order cardioid pick-up pattern, the Type 4015 and 4016 offer a wide cardioid pat- t e rn (see Fig. -
Page 3: Type
4011 and 4015: 158dB SPL peak). The 4011, 4012, 4015 and 4016 toge ther with the HMA4000 are t r a n s f o rmerless. All 4 microphones use state of the art low- n o i s e p r e a mp l i fier technology and are driven with unity ga i n . - Page 4 Fig. 1. Directional characteristics of Types 4011 and 4012. Shifts between emphasized circles indicate 10dB steps Fig. 2. Directional characteristics of Types 4015 and 4016. Shifts between emphasized circles indicate 5dB steps...
- Page 5 Fig. 3. On-and off-axis responses of Types 4011 and 4012 measured at 30cm. Fig.4 On-and off-axis responses of Types 40 15 and 4016 measured at 60cm.
- Page 6 Fig. 5. External view of the output socket of the Type 4011 and 4015. Fig.6 The switch on the XLR-connector of Type 401 1 and 4015 is used to select between 0dB and 20dB attenuation. Switch pressed in results in 20 dB attenuation.
- Page 7 Fig. 8. The proximity effect exhibited by the 401 1 and the 4012. Fig. 9. The proximity effect exhibited by the 4015 and the 4016.
- Page 8 Fig. 10. On-axis amplitude and phase responses of Types 4011, 4012, 4015 and 4016 plotted using a linear frequency axis for evaluation of the phase response. Fig. 11. Typical third-octave inherent-noise spectrum of Types 4011, 4012, 4015 and 4016.
- Page 9 Fig. 12. The effect of various cable lengths (loading capacitance) on the frequency response of the 4011 and 4015 (based on nominal sensitivity). For the 4012 and 4016 with the HMA4000 the curve shapes are the same, but the cable lengths are three times greater.
-
Page 10: Full Specifications
4012 and 4016: HMA4000 or PCC 4000 for 48V Frequency range: 4011 and 4012: On-axis: 40Hz to 20kHz ±2dB at 30 cm 4015 and 4016: On-axis: 40Hz ±2dB to 20kHz +3/-1dB at 60 cm with a max. 3 dB soft boost at 10 – 15 kHz Phase response: Phase matching between any two microphones: ±15°... - Page 11 P R EA M P L I F I E R : Frequency range: 4012 and 4016: 20Hz to 50kHz ±0.2dB, 5Hz to 150kHz -3dB 4011 and 4015: 20Hz to 40kHz -3dB (loaded with 2x10 kOhm// 10nF - equivalent to 100m cable) Output impedance: <220 Ohm...
-
Page 12: Type 40
F OR U SE WI TH M ICROPHO N E A M P L I F I E R HMA4000 Hi-Voltage Microphone Amplifier, 2 ch. ACC E SSORIE S IN CLU D E D Microphone Holders & Suspension Mounts UA0961 Microphone Holder Windscreens UA0896... - Page 13 The 3511 is a complete stereo kit for a broad range of recording appli- c a t i o n s using two carefully matched 4011 Cardioid Microphones. These cardioids are exceptionally linear in their frequency response - also off axis, giving you the natural experience. Several standard set-ups such as ORTF or XY are possible.
- Page 14 3511...
-
Page 15: Care Of Microphones
Please contact DPA Microphones for your nearest repre- sentative on Tel: +45 48 14 28 28 Fax:+45 48 14 27 00 You can also get in touch with DPA Microphones via the internet info@dpamicrophones.com using e-mail www.dpamicrophones.com... -
Page 16: Warranty
WA R R A N TY All products from DPA Microphones are covered by a two-year limited warranty on both mechanical functionality and documented specifications as long as the items are not mistreated, abused or modified in any way. In case of a warranty claim your invoice is your warranty registration.