Table of Contents
Advertisement
Users can select the next action from command buttons located at the top of the screen.
The Retrieve Filtered Report button prepares the report based on the filter criteria
specified by the user. The Retrieve Unfiltered Report button prepares the report with no
criteria specified (i.e., all data for the selected Account and Year are reported). Set Date
Range enables the user to filter the report by Date Entered, Date Modified, or Date Piped
range. Reset Filters enables users to revise the filter criteria by bringing up the filter
screen again. Cancel returns the user to the report selection screen.
Emissions are displayed in the report by Source and Point, then by Contaminant code.
Emissions are grouped by criteria pollutant category. From the display screen, users can
print the report or replicate the data in any one of several file formats, including Excel,
Dbase, "flat" file, etc. Next and Prior buttons make it easier to scroll down the report by
page rather than by screen (virtual page).
2.
Category and Contaminant Summary Reports
reports are available to the user to "roll up" emissions by criteria pollutant category,
Source, Point, Plant ID, or a combination. The Plant ID "roll up" reports will only show
those Source emissions for which the Source has previously been correctly identified as
belonging to the selected Plant ID.
3.
Permitted Emissions Compliance
number.
a.) Permitted Emissions Report. This report shows the actual and allowable emissions
rates for all contaminants, summed up by Emission Point, along with criteria pollutant
category totals of these rates. The right-hand column of the Permitted Emission
Report indicates emission records and criteria pollutant category totals for which the
actual rate exceeds the allowable rate. By changing the default setting in the
Emissions Detail screen for the data element Show Exceedance Value? to No, users
can suppress the flagging of apparent (but not actual) permit allowable exceedances
in the report.
4.
Control Efficiency Reports
a.) By Source ID, Point ID and Contam Name
b.) By Plant Process Unit and Contam Name.
5.
Maintenance
a.) Problem emission records.
This report helps users to review problem emissions records. After reviewing the
records user can correct the status of the equipment and rerun the report. Orphan
emissions records could be deleted using Global Maintenance function on Emissions
Maintenance menu.
7.1.2 Comparison Reports
This report enables the user to Compare Emissions for Two Years, Compare Emissions for Two
Accounts, Compare Emission Paths, and Compare Emission Paths with Contaminants. A user-
defined percentage change filter is also provided.
COMPASS-EI–Manual – Chapter 7
(Emissions "Roll-up") – Several
– Select the desired year, account number, and permit
Page 56
Advertisement
Table of Contents
