Setting Up Emission Points - Process Data Control COMPASS-EI User Manual

20. Equipment Leak Fugitives Information (Mandatory).
Equipment Type: Equipment Leak Fugitives
a.) % VOC In Gas Vapor.
What percent of the gas vapor stream is VOC ?
b.) % VOC In Lt Liquid.
What percent of the light liquid stream is VOC ?
c.) Calculation Method.
Which emissions factors were used to estimate the quantity of emissions?
Correlation Equations
Oil and Gas Factors
Petroleum Marketing Terminal Factors
Refinery Factors
Average SOCMI Factors
SOCMI Leak/ No leak
SOCMI Without Ethylene
SOCMI With Ethylene
Other
d.) LDAR Program In Use.
Is leak detection and repair program in use?
Yes
e.) LDAR Program Specified.
28LAER
28MID
28VHP
f.) Leak Definition.
Leak definition concentration in PPM
g.) Component Count
Represents numeric values of the leak definitions by component and component
counts by component type (valve, flange, etc.), material type (gas/vapor, light liquid,
heavy liquid, etc.) and service category (leaking, monitored, non-monitored, pegged,
total, etc.).

3.5 Setting Up Emission Points

Emission Point data consists of the following data items:
1. Emission Point Number (EPN) (Mandatory).
The appropriate emission point number that identifies the emission point. Must be unique
from other EPNs.
COMPASS-EI–Manual – Chapter 4
No
28M
28RCT
Page 30