Broadcast Tools ROS Installation And Operation Manual

Rack-o-switches

Advertisement

®
Installation and Operation Manual
ROS
Rack-O-Switches
Manual Update: 11/22/2004
Due to the dynamic nature of product design, the information contained in this
document is subject to change without notice. Broadcast Tools, Inc., assumes no
responsibility for errors and/or omissions contained in this document. Revisions
of this information or new editions may be issued to incorporate such changes.
Broadcast Tools® is a registered trademark of Broadcast Tools, Inc.
Copyright, 1989 - 2005 by Broadcast Tools, Inc. All rights reserved.
No part of this document may be reproduced or distributed without permission.
Visit www.broadcasttools.com for important product update information.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ROS and is the answer not in the manual?

Questions and answers

Summary of Contents for Broadcast Tools ROS

  • Page 1 Manual Update: 11/22/2004 Due to the dynamic nature of product design, the information contained in this document is subject to change without notice. Broadcast Tools, Inc., assumes no responsibility for errors and/or omissions contained in this document. Revisions of this information or new editions may be issued to incorporate such changes.
  • Page 2: Safety Information

    This manual should be tact your distributor from whom you purchased this equipment. read thoroughly before installation and operation. If you would like more information about Broadcast Tools® products, you may reach us at: Broadcast Tools, Inc. 131 State Street Sedro-Woolley, WA 98284-1540 USA Voice: 360 .
  • Page 3: Installation

    ROS Installation and Operation Manual INSTALLATION The Rack-O-Switches is equipped with twelve form A dry contacts and associated LED’s with current limiting resistors designed to operate with DC voltages between 5 and 24 vdc (polarity must be observed). Installation is simple. Install in any EIA format rack and secure with four rack screws.
  • Page 4: Limited Warranty

    If Broadcast Tools is notified, in writing, of a failure of any item manufactured by Broadcast Tools to conform to the foregoing Limited Warranty within one (1) year following the date of the Buyer’s acquisition of the item, and if the item is returned in to Broadcast Tools in accordance with Broadcast Tools’...
  • Page 5 Sedro-Woolley, WA 98284 • USA 360.854.9559 voice • 360.854.9479 support@broadcasttools.com e-mail www.broadcasttools.com website Visit the Broadcast Tools website or contact us via e-mail, phone, or fax for more information, additional manuals, and a list of dealers. © 2005 Broadcast Tools, Inc. All Rights Reserved...

Table of Contents