Step 6
1. Find the 2 x BACK UPHOLSTERY POSTS (8), L/R SEAT UPHOLSTER POSTS (8) & PIVOT ROD (15)
2. Assemble the parts so that the PIVOT ROD locates through the bust on the main frame support,
the SEAT UPHOLSTERY POSTS are either side with the 2 x BACK UPHOLSTERY POSTS are on
the outside. Add nuts, bolts & washers as shown.
3. Secure the BACK UPHOLSTERY FIXING BRACKET (11) in between the BACK UPHOLSTERY
POSTS using the detailed fixings. (Ensure that the orientation is correct.)
4. Finally insert the PULL PIN (38) through the angle brackets on the inside of the SET UPHOLSTERY
POSTS (This will allow the angle of the seat to be altered.)
TIGHTEN ALL FIXINGS AFTER STEP 8.
32 x 2
30 x 2
28 x 2
23 x 2
22 x 2
23
32
Large Hole
38
7
Angle brackets
on inside
www.yorkfitness.com
22
30
28
Large Hole
6
15
Back Upholstery
Fixing Bracket
11
22
8
32
23
11