Advertisement
REAR MOUNTING BRACKET and
1
SUPPORT PLATE (See Figs. 1 & 2)
Use Hardware - - GROUP "A"
•
Install support plate to inside of drawbar as shown, using
two (2) 7/16-14 x 3/4 hex bolts and the two threaded
upper holes in the plate. Do not tighten at this time.
NOTE: Be sure to align the four (4) lower threaded holes of
the support plate with the holes in the drawbar.
•
Assemble the mounting bracket as shown to the outside
of the drawbar using four (4) 7/16-14 x 3/4 hex bolts and
the four (4) lower threaded holes of the support plate.
Tighten all hardware securely.
HEX BOLTS
DRAWBAR
MOUNTING
BRACKET
HEX
BOLTS
DRAWBAR
ASSEMBLY
THREADED
UPPER HOLES
SUPPORT
PLATE
Fig. 1
SUPPORT
PLATE
THREADED
LOWER HOLES
Fig. 2
2
COVER SEAL (See Fig. 3)
No hardware required
•
Align mark on seal with mark at cover opening.
•
Work seal into opening so cover sits between flanges of
seal.
ALIGNMENT
MARKS
3
SUPPORT POST (See Fig. 4)
Use Hardware - - GROUP "B"
CAUTION: Container support is spring
loaded and locked to the cover. Handle
cover assembly carefully so as not to
unlatch the cover from the container
support.
•
Rotate cover assembly onto its side as shown.
•
Secure support tubes to cover assembly using short hex
bolts, long hex bolts, and locknuts as shown. Tighten
all hardware securely.
COVER
ASSEMBLY
LONG
HEX BOLTS
LOCKNUTS
S U P P O R T
POSTS
7
COVER SEAL
Fig. 3
SHORT
HEX BOLTS
LOCKNUTS
Fig. 4
Advertisement
