Advertisement
1
BAGGER SUPPORT ASSEMBLY
Determine which type drawbar you have on your tractor.
Compare the drawbar illustrations below to the drawbar
located at the rear of your tractor.
Follow the support assembly instructions that apply to your
type drawbar from the four listed below. Please note draw-
bars A and B are vertical, while C and D are angled.
DRAWBAR A
DRAWBAR C
If your tractor is equipped
with this illustration call
1-800-633-3522
for a replacement kit.
DRAWBAR A (See Figs. 1A & 1B)
1. Remove and discard the upper bolt on both sides of
the drawbar. Using the same holes, install the shoulder
bolts supplied and tighten securely.
ASSEMBLY
DRAWBAR B
DRAWBAR D
REMOVE AND DISCARD
UPPER BOLTS AND INSTALL
SHOULDER BOLTS SUPPLIED
DRAWBAR
Fig. 1A
2. Align support assembly pin with hole in drawbar and
hang assembly over the shoulder bolts.
3. Be sure support assembly is seated properly and secure
with retainer spring supplied.
SUPPORT AS-
SEMBLY
RETAINER
SPRING
DRAWBAR B (See Fig. 1C)
1. Discard adapters provided - not required for drawbar
type B.
2. Align support assembly pin with hole in drawbar and
hang assembly over the shoulder bolts.
3. Be sure support assembly is seated properly and secure
with retainer spring supplied.
SUPPORT AS-
SEMBLY
RETAINER
SPRING
5
SHOULDER
BOLTS
Fig. 1B
SHOULDER
BOLTS
3064
PIN
Fig. 1C
PIN
Advertisement
