Timer Button - Ecoair ECO8P Installation And Operation Manual

Notice: This is a general use remote controller, it could be used for the air conditioners with
multifunction; For some function, which the model dosen't have, if press the corresponding button
on the remote controller that the unit will keep the original running status.
Remote
Control
+
For presetting temperature increasing.
Press this button,can set up the temperature, when
unit is on . Continuously press and hold this button for
more than 2 seconds, the corresponding contents will
be changed rapidly, until unpress the button
then send the information,
along. In Auto mode, the temperature can not be set
up, but operate this button can send the signal.
Centigrade setting range :16-30; Fahrenheit scale
setting range 61-86.
-
Presetting temperature can be decreased.
Press this button, the temperature can be set up,
continuously
seconds, the relative contents can quickly change,
until unhold this button and send the order that the
(oF) signal will be displayed all the time. The
temperature
Auto mode, but the order can be sent by if pressing
this button.
+ button
is displaying all
- button
press this button and hold for two
adjustment is unavailable under the
10
Timer

TIMER button

- By pressing this key under switch-off state, you may set
the time for auto switch-on. The range of setting is 0.5 ~ 24
hours. The characters "T-ON" and "H" will flash for 5
seconds. Within 5 seconds,you may make one press of this
key to complete the setting and send the message.If the
setting is valid, the set time will be displayed for 2 seconds
before display of the temperature message.
During flash, you may press "+" key to increase the value and
press "-" key to decrease the value. The time will increase or
decrease by 0.5 hours with each press of this key.
If pressing "+" or "-" key continuously, the time value will
change rapidly. The remote controller can increase the set
time by 0.5 hours every 0.25 seconds. After being energized,
the fault is no timer setting, and there is no display of "T-ON"
or "H". Press ON/OFF key to switch on the unit and cancel
the auto switch-on. When the temperature display becomes
constant, you may press this key again to display the
remaining set time. The time value, "T-On" and "H" will
display constantly for 2 seconds. After 2 seconds, the preset
temperature will be displayed. Within these 2 seconds, you
may press this key again to cancel the auto
switch-on and send the message.
By pressing this key under switch-on state, you may set
-
the time for auto switch-off. The method of setting as the
same as for auto switch-on.