Manual Code Entry - Marmitek X-10 User Manual

Note: The Letter Code selected must be the same as the
Letter Code used by your RFIX35 RF-interface.
RF-secured mode
In the RF-secured mode the RF-interface (RFIX35) will only
respond to remote controls that have been linked to the
RFIX35. This prevents others to control your lights and
appliances. To set the RFIX35 in the RF-secured mode please
refer to the RFIX35 manual.
To be able to use the RF-secured mode, the Marmitek X-10
remote control will have to be set in the RF-secured mode.
To set the Marmitek X-10 remote control into the RF-secured
mode please follow the next steps.
Set the ABX1 to the RF-secured mode
1. Program code 822 under the Marmitek X-10 button.
• Press SETUP button until the LED stays lit
• Press the Marmitek X-10 button
• Enter 8-2-2 , the LED will switch off after the last
2 buttons are pressed
2. Press the Marmitek X-10 button.
3. Press the SETUP button until the LED stays lit.
4. Release the SETUP button.
5. Press the AV button to generate a random security code.
6. Press the -/-- button.
Reset the Remote Control to the standard mode
(= non RF-secured mode)
To reset the ABX1 to the standard mode, program code 820
under the Marmitek X-10 button.
• Press the SETUP until the LED stays lit.
• Press the Marmitek X-10 button.
• Press 8-2-0, the LED will switch off after the 0 button is
pressed.

4.2 Manual code entry

Take your code book and search for the list matching the
equipment you are looking for, e.g. TV or VCR. Next, find
the relevant brand (e.g. Sony). Now you will find one or more
3-digit codes. If there is more than one code, it depends on
your equipment which code is correct.
Generally, the codes are displayed in order of age of the
equipment. Older equipment first, younger equipment at the
end. Sometimes you will have to try several codes before
you find the right code for your equipment.
1. Make sure your equipment is switched on (for example
TV).
2. Press and hold the SETUP (8) key until the LED indicator
lights continuously. Release the SETUP key.
3. Press and release the mode key (3) of the device you
want to control (for example TV).
4. Enter the 3 digit code from the Code Book by using the
key pad (9). The LED (2) turns off after the last digit is
entered. If you entered a wrong code the LED blinks for 3
seconds and then goes off. You have to repeat from step 2.
5. Point the remote in the direction of your TV and press the
POWER button (1). Your device should turn off. Check other
functions (for example for a VCR FF or REW, etc.). If certain
functions are not responding, this indicates that the entered
code is not the correct one. In that case repeat the above
procedure with the next corresponding code of your brand.
25