Manual Code Search; Learning Codes - Marmitek X-10 User Manual

per second). When the device responds, you can press
CHAN+ (5) to switch to slow search (1 code per 3 seconds).
You can step back by pressing CHAN- (5) (you can step
forward by pressing CHAN+ (5) in case you went too far
back). As soon as the device responds again, press the -/-key
(11) to store the code you found.
Remark: if some functions of your equipment don't work,
you need to try another code for your brand. The
search function starts after the last confirmed code. For
example, if it was 030, the search function starts at 031, and
it will keep on trying until the last possible code.

4.5 Manual code search

Note: as you can dedicate any appliance (TV, DVD, SAT...)
to the VCR, CBL, DVD, etc. keys, you first need to enter any
3 digit code for the kind of appliance you wish to control
(found in the code book), i.e.: If you want to program a SAT
under the AUX key, enter ANY SAT code found in the code
book and then follow the steps below:
1. Make sure your equipment is switched on.
2. Press and hold SETUP (8) until the LED indicator lights
steadily. Release SETUP
3. Press the mode key (3) that matches the equipment you
want to control (for example TV).
4. Press CHAN+ (5) repeatedly until the channel changes. If
you step past the correct code use CHAN- (5) to go back to
the right code.
5. When the equipment you want to control reacts, press -/-(
11) to confirm the code.
Note: If your equipment doesn't have CHAN+ you can use
PLAY (VCR or DVD) (19) or POWER (1) key.
Note: if certain functions of your equipment can't be
controlled you will have to find a different code for your
brand. The search starts after the last registered code. If that
was 030, the search starts at 031 until the last possible code
and then goes from 000 to 029.

4.6 Learning codes

Your Marmitek X-10 Remote contains the codes for most
TVs,
videos etc. in its code library. If a certain device is not in this
library, you can learn the codes for your existing remote
control. The library may also contain a code that works for
your device, but which misses a few function buttons. You
can then select to only learn those buttons (maximum of 150
buttons).
Master clear
You can use the MASTER CLEAR method to clear the
learning memory. It is advised to execute a MASTER
CLEAR before you start learning any commands.
1. Keep the SETUP (8) pressed until one of the Mode LED's
stays lit. Release the SETUP (8) button.
2. Press the LEARN (24) button twice. The LED will flash
every time you press the button.
3. Press SETUP (8). The LED will extinguish after a few
seconds.
27