Programming - Marmitek X-10 User Manual

English

4. Programming

To make your remote suitable for your own equipment, you
have to program it once. You can do this by entering a code,
related to the brand and type of equipment you want to
control. You can program any equipment under any MODE
key. For example, if you have three videorecorders, you can
e.g. assign videorecorder 1 to VCR, videorecorder 2 to DVD
and videorecorder 3 to DVR. The TV button can be used for
TV only.
4.1 Controlling your house with Marmitek X-10 Automation
The Marmitek X-10 remote control allows you to control all
lights and electric appliances you have in your house. Here
are some examples that you can do with your Marmitek X-10
remote using Marmitek X-10 modules:
• Switch on/off, dim lights while you watch TV.
• Switch on the lights at night to frighten intruders when
you detect something suspicious
• Switch on your electric blanket before the film ends to
have it warm when you go to sleep
To be able to control your lights and appliances you need a
Marmitek X-10 RF-interface (RFIX35) and Marmitek X-10
modules. Contact your dealer for further information.
You can control the Marmitek X-10 Automation Modules as
follows:
Make sure that the Marmitek X-10 remote control is programmed
on the same Letter Code as the RFIX35 RF-interface and the
modules installed in your house (see changing the Marmitek X-
10 Letter Code).
1. Press the Marmitek X-10 button.
2. Use the numerical keys to select the Unit Code of the
Module of your choice (1-digit codes do not have to
preceded by a '0').
3. Press the button of the function you want to execute (see
overview below).
Marmitek X-10 Automation functions:
On: CHANNEL +
Off: CHANNEL -
Brighter: VOLUME +
Dim: VOLUME -
All lights on: X Power
All units off: Mute
_
Changing the Marmitek X-10 Letter Code
The Marmitek X-10 Remote is set to Letter Code A by
default.
In most cases you do not need to change this setting, unless
another Marmitek X-10 or X10 compatible system in your
area causes interference. In case of interference we advice
to set the remote control and the RFIX35 in the RF-secured
mode (see "RF-secured mode").
1. Press the SETUP button until one of the Mode LED's
stays lit. Release the SETUP button.
2. Press the numerical key(s) for the Letter Code selected
(1=A, 2=B, ...... 16=P).
3. Press the -/-- (12) button to confirm the Letter Code. The
LED will extinguish.
24