Pci-X Expansion Board Basket; Removing The Expansion Board Basket - HP ProLiant DL580 Generation 2 Maintenance And Service Manual

PCI-X Expansion Board Basket

To remove the PCI-X expansion board basket:
1. Power down the server. Refer to "Power ing Down the Server" in this chapter.
2. Extend the server from the rack. Refer to "Extending the Rack from the Server" in this
chapter.
3. Open the rear access panel. Refer to "Op ening and Removing the Rear Access Panel" in
this chapter.
4. Unplug all cables attached to the expansion board at the rear of the server.
5. Remove all PCI-X Hot Plug expansion boards from the basket. Refer to "PCI and PCI-X
Hot Plug Expansion Boards" in this chapter.
IMPORTANT: If no expansion board is installed in PCI-X slot 1, remove the expansion slot cover.
6. Pull up on the two plastic rivets to disengage them from the front fan cage (1).
7. Pull up on the side of the basket at the front of the server and tilt it up to a 45° angle (2).
8. Slide the entire basket toward the front of the server and lift the basket out of the
chassis (3).
Figure 2-40: Removing the expansion board basket
Reverse steps 1 through 8 to replace the expansion board basket.
HP ProLiant DL580 Generation 2 Server Maintenance and Service Guide
Removal and Replacement Procedures
2-53