HP ProLiant DL580 Generation 2 Maintenance And Service Manual page 46

3. Install the required DIMMs based on your desired memory configuration. Be sure to
follow all DIMM installation requirements. Refer to "DIMM Installation Requir ements"
in this chapter for the desired memory configuration.
4. Install the memory board. Refer to "Ins talling a Memory Board" in this chapter.
5. Configure the DIMMs:
a. Power on the server.
b. Press the F9 key to enter RBSU.
c. Select Advanced Options.
d. Change POST Speed Up to disable (to test the replaced memory).
e. Press any key to return to the RBSU main menu.
f.
g. Select Advanced Memory Protection.
h. Select the desired memory mode.
i.
j.
k. Once the memory has been tested, re-enable POST Speed Up for faster system boot,
IMPORTANT: To reconfigure the memory mode after initial setup, you must reboot the system
and enter RBSU.
HP ProLiant DL580 Generation 2 Server Maintenance and Service Guide
Select System Options.
Press the Esc key twice to go back to the main RBSU menu.
Press the F10 key to exit RBSU. The server reboots and tests all memory in the
system.
if desired.
Removal and Replacement Procedures
2-29