System Id Switch (Sw7); System Id Switch (Sw7) - HP ProLiant DL580 Generation 2 Maintenance And Service Manual

Connectors, LEDs, and Switches
Enabling ROMPaq Disaster Recovery Mode
A corrupted system ROM requires you to recreate the ROM BIOS by using the ROM flash
utility. This can be accomplished only when the system is in disaster recovery mode. Set
configuration switches 1, 4, 5, and 6 on the system maintenance switch block to on to enable
disaster recovery mode.
IMPORTANT: Before enabling ROMPaq disaster recovery mode, refer to the HP Servers
Troubleshooting Guide for complete instructions on disaster recovery.

System ID Switch (SW7)

Figure 4-18 and Table 4-21 identify the system ID switch location and settings.
Figure 4-18: System ID switch (SW7)
Table 4-21: System ID Switch (SW7)
Position
1 through 3
4-26
Default Function
Chassis ID Used to allow 8
ID combinations,
if used as
another system.
HP ProLiant DL580 Generation 2 Server Maintenance and Service Guide
Description Settings