Calibration - Oki C711WT User Manual

C
ALIBRATION
ITEM
Auto Density
Mode
Adjust Density
Adjust
Registration
Print Tuning
Pattern
Cyan/Magenta/ Highlight
Yellow Tuning
Mid-Tone
Dark
Cyan/Magenta/
Yellow/White
Density
SETTINGS EXPLANATION
On/Off Selects whether density adjustment and TRC
compensation is automatically performed.
On: Density adjustment is automatically run under the
engine-specified conditions, and reflected in TRC
compensation.
Off: The printer does not voluntarily run density
adjustment.
Execute If Execute is selected, the printer will immediately
adjust density and reflect it in TRC compensation.
This adjustment must be executed when the
printer is idling. It can become invalid if executed
in any other state.
Execute When this menu is selected, the printer performs
AutoAdjust Registration.
This adjustment must be executed when the
printer is idling.
Execute Prints the pattern for the user to adjust TRC.
Ordinarily, this function is not needed because TRC is
automatically adjusted to the recommended levels
through density adjustment and TRC compensation.
Adjustment results will be reflected as offset values
(addition) to the corrections through the Adjust
Density/TRC Compensation function.
-3,-2,-1, Adjusts HIGHLIGHT (light area) of the TRC.
0,+1,+2,+3,
+ = Darker
- = Lighter
-3,-2,-1, Adjusts MID-TONE area of the TRC.
0,+1,+2,+3,
+ = Darker
- = Lighter
-3,-2,-1, Adjusts DARK area of the TRC.
0,+1,+2,+3,
+ = Darker
- = Lighter
-3,-2,-1, Adjusts the engine density.
0,+1,+2,+3,
Menu functions > 54