Oki C711WT User Manual page 51

ITEM
Print Setup Resolution
(cont.)
X Dimension
Y Dimension
PS Setup Network
Protocol
Parallel
Protocol
USB
Protocol
Color Setup CMY 100%
Density
Memory Receive
Setup Buffer Size
Resource
Save
SETTINGS EXPLANATION
600dpi Sets default resolution.
600x1200dpi
600dpi multi-
level
64 mm Specifies paper width of Custom paper as a default value.
~ Sets a paper size at right angles to the paper run
direction.
210 mm
~
216 mm
127 mm Specifies paper length of Custom paper as a default value.
~ Sets a paper size in the same direction as the paper run
direction.
297 mm
~
1321 mm
ASCII/RAW Specifies PS communication protocol mode of data from
NIC port.
(In RAW mode, Ctrl-T is invalid). PS models only.
ASCII/RAW Specifies PS communication protocol mode of data from
Centronics port.
(In RAW mode, Ctrl-T is invalid). PS models only.
ASCII/RAW Specifies PS communication protocol mode of data from
USB port.
(In RAW mode, Ctrl-T is invalid). PS models only.
Enable/Disable Enable/Disable 100% output against the CMY100% TRC
compensation. Ordinarily, the TRC compensation function
holds control for the appropriate print density; thus 100%
output is not always possible.
Selecting ENABLE will enable 100% output in any
individual color. The actual print, including the TRC
compensation function is limited to an appropriate area.
This function is for special purposes such as specification
in CMY color reduction in PS.
Auto Sets the size of receive buffer
0.5 megabyte
1 megabyte
2 megabyte
4 megabyte
8 megabyte
16 megabyte
32 megabyte
Auto Sets the size of resource saving area.
Off
0.5 megabyte
1 megabyte
2 megabyte
4 megabyte
8 megabyte
16 megabyte
32 megabyte
Menu functions > 51