Calibration; Print Statistics - Oki C710n User Manual

C
ALIBRATION
ITEM
Auto Density
Adjust Density
Adjust
Registration
Print Tuning
Pattern
Cyan/Magenta/ Highlight
Yellow/Black
Tuning
Mid-Tone
Dark
Cyan/Magenta/
Yellow/Black
Darkness
P S
RINT TATISTICS
ITEM
Enter Password
Section
Counter
Reset Group
Counter
SETTINGS
On/Off
Execute
Execute
Execute
-3,-2,-1,
0,+1,+2,+3,
-3,-2,-1,
0,+1,+2,+3,
-3,-2,-1,
0,+1,+2,+3,
-3,-2,-1,
0,+1,+2,+3,
SETTINGS
XXXX
Enable/Disable
Execute
Menu functions > 35
EXPLANATION
Enables/disables automatic density adjustment.
If Execute is selected, the printer will immediately
adjust density and reflect it in TRC compensation.
This adjustment must be executed when the
printer is idling. It can become invalid if executed
in any other state.
When this menu is selected, the printer performs
AutoAdjust Registration.
This adjustment must be executed when the
printer is idling.
Prints the pattern for the user to adjust TRC.
Ordinarily, this function is not needed because TRC is
automatically adjusted to the recommended levels
through density adjustment and TRC compensation.
Adjustment results will be reflected as offset values
(addition) to the corrections through the Adjust
Density/TRC Compensation function.
Adjusts HIGHLIGHT (light area) of the TRC.
+ = Darker
- = Lighter
Adjusts MID-TONE area of the TRC.
+ = Darker
- = Lighter
Adjusts DARK area of the TRC.
+ = Darker
- = Lighter
Adjusts the engine density.
The Darkness settings for each of CMYK will be
reflected as offset values (addition) to the corrections
through the Adjust Density/TRC Compensation
function.
EXPLANATION
Enters a password to enter Print Statistics menu.
The default value is "0000".
The password for entry to Print Statistics is different
from the password for entry to Functions-Admin Setup.
"Print Statistics" category is not shown when Print
Statistics function is not supported.
Specifies if the section counter is displayed in Usage
Report Print or not.
Enable: Displayed, Disable: Not displayed.
Enable must be selected in Functions/Print Statistics/
Usage Report
Resets the main counter to zero.
When executing this menu, resets the main counter to
zero and exits from the menu.
Enable must be selected in Functions/Print Statistics/
Usage Report.