Solid-State Drive - HP EliteBook 820 G1 Maintenance And Service Manual

Solid-state drive

Description
256-GB, SATA-3, SED solid-state drive
240-GB, SATA-3, solid-state drive
180-GB, SATA-3, solid-state drive
128-GB, SATA-3, solid-state drive
120-GB, mSATA-3, SED solid-state drive
32-GB, SATA-3, solid-state drive
Before removing the solid-state drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service cover (see
5. Remove the battery (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.5 screw (1) that secures the solid-state drive to the system board.
(The solid-state drive tilts up.)
Service cover on page
Battery on page 44).
42).
Component replacement procedures
Spare part number
730567-001
730566-001
730765-001
744716-001
730568-001
743008-001
51