Adjustment
11.
Lateral alignment of the thread catcher
06.02
11 - 22
Requirement
1. The tip of the thread catcher 5 must point exactly to the center of the needle.
2. The thread catcher 5 must be horizontal. It must not graze anything when it is
operating.
Fig. 11 - 21
Remove knife 1 (screw 2).
Move needle bar to its BDC.
Loosen stop 3 (screws 4).
Position thread catcher 5 (screw 6) manually in front of the needle.
Align thread catcher 5 (screws 7) according to the requirements.
For further adjustments, knife 1 remains dismantled and stop 3 loosened.
5
7
3
1
2
4
6
5