Related Manuals for Pfaff Tipmatic 1014
Summary of Contents for Pfaff Tipmatic 1014
- Page 6 Gu!&as lea! JOddiz piepuei 6U1M89 4004 qo1{Jspuig M8iA-JBefQ 4004 bunne 4oo, ejoquon 100,t ep:n6 Jewuiej...
- Page 9 righE of...
- Page 10 RI__II... LI_.._1 __.J...
- Page 17 Finger-tip controls on Model 1019 A, B, C; Buttons for buttonholing Button B is also used as clearing button for releasing the pushed buttons and for setting the left needle position (see page 17). D Elastic triple zigzag stitch, 2 mm 2-mm zigzag stich E Elastic triple zigzag stitch, 3.5 mm 3.5-mm zigzag stitch...
- Page 22 Dropping the machine feed Changing the needle Remove cover 108 or free arm cover 122. Raise the needle bar. Then hold the needle, Open free arm cover 122. Push the loosen screw N and pull the needle out drop-feed control toward N. The feed dog is downwards.
- Page 25 it will...
- Page 29 Cause: Remedy: 4. Seam is not uniform Tension out of adjustment. Check upper and lower tensions. Thread too thick, knotty or hard. Use first-class thread only. Bobbin thread wound unevenly. During bobbin winding, do not hold thread in hand, but pass it through the bobbin tension stud.
- Page 30 ..‘.— -..- —.--- -.---.- .._-.•-.. ---.
- Page 34 PFAFF-HANDELSGESELLSCHAFr für Haushaftnãhmaschinen m. b. H. Subject to atterations 7500 Karlsruhe 41 West-Germany...
Need help?
Do you have a question about the Tipmatic 1014 and is the answer not in the manual?
Questions and answers
My pfaff 1011 needle does not move at all
The needle on the Pfaff Tipmatic 1014 may not be moving due to the drop-feed control being engaged. For sewing, the drop-feed control should be pushed toward "0." Additionally, ensure that the needle is properly installed with the flat side of its shank facing the correct direction and fully inserted before tightening the screw.
This answer is automatically generated