Operation - QEP 650XT Owner's Manual

FIGurE 8
inStaLLinG tHe anGLe GUide
(see FIGURE 9)
1. The angle guide is designed to fit on top of
the rip guide . Simply place angle guide onto
the top of the rip guide .
NOTE: The angle guide can be placed on either
the left or right side .
FIGurE 9

OPERATION

IMPORTANT: AlWAYS turn off the saw and
remove the plug from the outlet BEFORE
adding or removing accessories and making
adjustments .
THE SAW COULD RESULT IN ACCIDENTAL
STARTING CAUSING POSSIBLE SERIOUS
PERSONAL INJURY.
FAILURE TO UNPLUG
BeFOre StartinG tHe SaW
1 . Make sure saw is unplugged .
2. Remove the right cutting table and fill the
water reservoir to the top of the overflow
opening (see FIGURE 10). Do not fill above
this level .
NOTE: AlWAYS keep enough water in the
reservoir when operating the saw . DO NOT let
the saw run dry .
3 . Re-attach and close right cutting table .
ImporTANT: ALWAyS completely drain the
water reservoir and clean thoroughly after
each use.
FIGurE 10
tO Start tHe SaW
1 . Remove cord from compartment under the
saw and connect it to a GFCI (Ground Fault
Circuit Interrupter) protected outlet (see
FIGURE 11) .
3 .Push On/Off switch to the "On" position .
FIGurE 11
2 . Create "drip loop" in the cord (see
FIGURE 12) .
– 7 –