Main Washer - Electrolux T5675 Service Manual

120

MAIN WASHER

11:1 NO WATER
This error is shown if the programmed water level is not reached within a certain time, typically
10 minutes.
Max. filling time is defined in Config. 1 parameter MAX FILL TIME.
This error message can be turned off in Configuration - Error code.
Possible causes:
Long filling times can be caused by a leaking drain valve, blocked filler valve, defective filler valve,
defective valve control board, clogged level sensor hose, leaking level system, etc.
Recommended actions:
1. Check for leaking drain valve by filling water to high level in service program.
2. Check for leaking or clogged level sensor system by filling water to high level in service program
and then actual level in inputs.
3. Check for malfunction or block filler valve by activating input by input in service program.
4. Monitor a program by using Process viewer in ELS Common Service Tool.
11:2 DOOR OPEN / LOADING DOOR OPEN
This error code will be shown if the control system detect that the input DOOR CLOSED has been
deactivated during an on-going program. This error code can only occur during an on-going
program.
Possible causes:
This can be caused by for example a bad or defective door lock, loose cable to door lock, problem
with door lock edge connection, defective input on I/O unit type 10 etc.
Recommended actions:
1. Check door lock functionality in service program, but activating door lock and then by checking
inputs.
2. Check electrical connections by reading inputs at the same time as cables carefully
moved/pulled.
3. Carefully knock on the door lock to locate intermittent errors.
Troubleshooting