Electrolux T5675 Service Manual page 29

Motor
29
Put the belt in position (C) and tighten the screws (1, 2, 3, 4 starting with 4).
Check the belt tension with a frequency meater or similar. The frequency shall be 80 Hz ± 5.
Adjust if necessary. Check that 5 is tightened.
31
1 2 3 4
5
fig.49077800A
Remount the motor module in the machine.
Fasten the belt (B) and the wire (A). Make sure the belt is in position.
Tighten the belt tensioner with a torque wrench by pulling the tension plate (E) clockwise until
it is in position.
Check the belt tension with a frequency meater or similar. The frequency shall be 75 Hz ± 5.
Adjust if necessary.
32
B
E
B
A
fig.7220D
Connect the motor cable.
Remount the cover panel and the rear panels.
Note!
The machine will NOT work without the cover panel.