Electrolux T5675 Service Manual page 137

13:12 LOADING DOOR NOT LOCKED
Same error as 11:3 but will only occur in program run.
This error code will be shown if the control system have not detected the input DOOR LOCKED to
be active within a certain time after program start, typically 3 seconds.
Possible causes:
This can be caused by a mechanical problem preventing door lock to lock, defective door lock,
loose cable connection to door lock, broken cables to door lock or mechanical problem with
emergency opening of the door.
Recommended actions:
1. Check door lock functionality in service program, by activating door lock and then by checking
check inputs.
2. Check electrical connections by reading inputs at the same time as cables carefully
moved/pulled.
3. Carefully knock on the door lock unit to locate intermittent errors.
4. Check DLCU status in service mode for more information on possible causes.
13:13 UNLOADING DOOR NOT LOCKED
This error code will be shown if the control system detects that the input DOOR LOCKED 2 has not
been activated within a certain time after unloading door is closed.
It will also be activated if the input DOOR LOCKED 2 has been deactivated during an on-going
program.
Possible causes:
This can be caused by a mechanical problem preventing door lock to lock, defective door lock,
loose cable connection to door lock, broken cables to door lock or mechanical problem with
emergency opening of the door.
Recommended actions:
1. Check door lock functionality in service program, by activating door lock and then by checking
check inputs.
2. Check electrical connections by reading inputs at the same time as cables carefully
moved/pulled.
3. Carefully knock on the door lock unit to locate intermittent errors.
Troubleshooting
137