Mounting And Flying Hardware - Tannoy VLS 7 Operation Manual

8. Mounting and flying

8.2 Mounting and flying hardware

Wall Bracket – Each VLS Series loudspeaker is supplied with a standard wall bracket suitable for mount-
ing on most wall surfaces. The bracket is supplied as two interlocking U plates. One plate attaches to the rear
of the loudspeaker with four supplied screws. The other part is secured to the wall. The bar on the bottom of
the speaker plate slides into the bottom notch of the wall plate, while the top is secured with the two supplied
screws. The bracket for the VLS 7 and 15 is slotted to allow an angle between 0 and 6 degrees (Fig.3). Aligning
the top two screw holes of the VLS 30 results in a flat flush mount; using the lower two screw positions provides
a 4 degree downward tilt. (Fig.4)
Fig.3 VLS 7 & VLS 15 Fig.4 VLS 30
Flying Bracket – Each VLS Series loudspeaker is also supplied with a flying bracket. The bracket is attached
to the top two inserts using the supplied M6 screws (Fig.5). The two bottom inserts can be used as pull back
if required.
10
VLS Series Operation Manual rev 1.1.0