Ready Light; Stay Light; Zone Light; Emergency Activation Keys - GE NetworX NX-8E User Manual

Ready Light

The ready light is "on" when the system is ready to arm and "flashes" if ready to
force arm. The ready light is off when the system is not ready to arm because
of a zone(s) being faulted.

Stay Light

The stay light is "on" when the all interior (motion detector) zones are
bypassed.

Zone Light

The zone lights are "off" when everything is normal. A zone light will be "on" if
the zone has been bypassed. If a zone light is "flashing", that zone is in alarm
or has been faulted. If a zone light is "flashing" rapidly, it means that the zone is
in a trouble condition. Trouble conditions are:
Tamper
(A combination of Alarm/Fault and Tamper/Trouble will produce a rapid
"flashing" light for a short period of time, followed by a slow "flashing" light.)

EMERGENCY ACTIVATION KEYS

NOTES: You must hold these keys for 2 seconds to activate these
functions. Your system may not be programmed for these activation keys
(see page 1). You should press these keys only in an emergency situation that
requires response by emergency personnel.
these functions, the following reports can be sent.
Fire Key – This key can activate the fire alarm when pressed for two seconds. If
your system is connected to a monitoring center, an emergency report could be
sent to that center.
Auxiliary Emergency Key – This key can activate the auxiliary alarm when
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be sent to that center.
Police (Panic/Hold-Up) Key - This key can sound a local audible alarm when
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be transmitted to that center. NOTE: Some Panic/Hold-
Up alarms are programmed to be silent at the protected site while reporting an
alarm to the monitoring center. Check with your installing company to determine
how your security system will respond to the Panic/Hold-Up activation.
Hardware Low Battery
If your system is programmed for
8
Loss of Supervision