Reset Function; Setting The System Clock; Set System Date - GE NetworX NX-8E User Manual

RESET FUNCTION

This function is used to reset Smoke Detectors, Zone Troubles, and Zone
Tampers.
Step 1 Disarm the system if not disarmed.
Step 2 Press [r]-[7]. Resets have now been performed.
Step 3 If the keypad begins beeping, the reset did not execute properly.
Enter your code to silence the keypad. Wait a few minutes and
repeat step 2 to attempt another reset. If the keypad still beeps after
repeated attempts, please contact your installer.

SET SYSTEM DATE

Step 1 Press the [r]-[9]-[6].
Step 2 Enter the "Master Code".
Step 3 Enter the "Day of Week "
1 = Sunday
2 = Monday
Step 4 Enter the "Month Code". Must always be two (2) digits.
01 = January
02 = February
03 = March
04 = April
Step 5 Enter the "Day Code". Must always be two (2) digits.
Example: The 5
Step 6 Enter the last two digits of the "Year Code".
Example: For 1997 enter [9]–[7].

SETTING THE SYSTEM CLOCK

Step 1 Press [r]-[9]-[7].
Step 2 Enter the "Master Code ".
Step 3 Enter the "hour code" which must be two (2) digits. Note: The clock
is a 24-hour clock. Refer to the following table on page 16.
Step 4 Enter the "minutes code" which must be two (2) digits.
Example: 7 minutes after would be entered [0]–[7].
3 = Tuesday
4 = Wednesday
05 = May
06 = June
07 = July
08 = August
th
would be entered as [0]–[5].
15
5 = Thursday
6 = Friday
09 = September
10 = October
11 = November
12 = December
7 = Saturday