Fitting The Cutting Unit; Installing Bioclip 90 - Husqvarna 16 Operator's Manual

Fitting the cutting unit

1. Place the Rider on a flat surface and apply the
parking brake. Check that the lever for setting the
cutting height is in the lowest position.
Make sure the support wheels are fitted to the
cutting unit (1).
2. Grasp the handle at the front (BioClip 90) or hold
the frame of the cutting unit (2) and slide the unit
underneath the rider mower, making sure that
the tongue on the cutting unit (3) engages
correctly.
3. Insert the bolt and secure it with a locking pin.
WARNING!
Observe caution to avoid trapping
your hand.
4. Press down the frame and insert the pin. Fit the
drive belt around the drive wheels of the cutting
unit.
5. Hook up the height adjustment strut.
6. Fit the front cover.
7. Secure the collet's spring, see ring in the
diagram below.

Installing BioClip 90

In order to install BioClip 90 the drive belt support
wheel must first be removed.
1. Release the tensioning wheel's spring, see ring
in the diagram.
2. Remove the locking pin (1) that is located next to
the support wheel.
3. Screw off the nut and washer (2) under the
centre of the support wheel. Remove the screw
and support wheel.
4. Fit the cutting unit according to the instructions
above.
28
– English
MAINTENANCE
1
3
2
6017-159
6017-120
6017-160
1
2
6017-142