Adjusting The Parallelism Of The Cutting Unit; Dismantling The Cutting Unit - Husqvarna 16 Operator's Manual

Adjusting the parallelism of the cutting
unit
1. Remove the front hood and right-hand fender,
as described on page 21.
2. Undo the nuts on the lift strut.
3. Unscrew the strut (anticlockwise) to lower the
rear edge of the hood.
Screw the strut in (clockwise) to raise the rear
edge of the hood.
4. Tighten the nuts after adjustment.
5. On completion of the adjustment the unit's
parallelism should be re-checked.
6. Fit the right-hand fender and the front hood.
Removing the cutting unit
WARNING!
Wear protective glasses when
dismantling the cutting unit. The
spring which tensions up the belt
can go off and cause personal
injury.
1. Carry out points 1-9 to put the cutting unit in the
service position, see "Service position for the
cutting unit" on page 33.
2. Remove the bolt (3) and lift off the cutting unit.
Fitting of the cutting unit takes place in the reverse
order to removal. See page 28 for details of how to
fit the BioClip 90.
When assembling: Make sure that the unit's "lug"
enters the loop correctly on the underside of the
machine.
30
– English
MAINTENANCE
1
6017-018
2
3
6017-021
8009-123