Download Print this page

General Working Instructions - Husqvarna 1152417-30 Operator's Manual

Husqvarna electric stand drill operator's manual
Hide thumbs

Advertisement

Use and care
Never use a machine that is faulty. Carry out the checks,
maintenance and service instructions described in this
manual. Some maintenance and service measures must
be carried out by trained and qualified specialists. See
instructions under the heading Maintenance.
Inspection and/or maintenance should be carried out with
the motor switched off and the plug disconnected.
Do not use the power tool if the switch does not turn it on
and off. Any power tool that cannot be controlled with the
switch is dangerous and must be repaired.
Never use a machine that has been modified in any way
from its original specification.
Do not overload the machine. Overloading can damage
the machine.
Keep tools sharp and clean in order to enable safer work.
Keep all parts in good working order and ensure that all
fixtures are properly tightened.
Transport and storage
Do not store or transport the drilling machine with the drill
bit fitted in order to protect your drilling machine and drill
bits from damage.
Store the drilling machine in a lockable area so that it is
out of reach of children and unauthorised persons.
Store the drilling machine and stand in dry and frost free
conditions.
8 –
English
SAFETY INSTRUCTIONS

General working instructions

WARNING! This section takes up the basic
!
safety precautions for working with the
drilling machine. This information is never a
substitute for professional skills and
experience. If you encounter a situation
where you are uncertain how to proceed you
should ask an expert. Contact your dealer,
service agent or an experienced drilling
machine user. Do not attempt any task that
you feel unsure of!
The machine has a very high torque. This demands good
concentration during work, as serious personal injuries
can occur if the drill bit suddenly jams.
Keep your hands at a safe distance from the drill spindle
and drill bit when the machine is running.
Keep an eye open for oil or water leakage. If water or oil
trickles out from the leakage hole on the top of the pinion
neck, the seals must be replaced.
Stand drilling
The machine is intended for stand mounted drilling.
The following Husqvarna drill stands are recommended
for use with the drill motor:
- DS 50 AT/ATS/Gyro/COMBO/BASIC
- DS 70 AT/ATS
- DS 450 ATS
Make sure that the stand is secured correctly.
Make sure that the drilling machine is secured correctly in
the stand.
Drilling outdoors
Always use extension cables that are approved for
outdoor use.
Drilling in ceilings and the like
Use a water collector to avoid water penetrating into the
machine.

Advertisement

loading

  Related Manuals for Husqvarna 1152417-30

This manual is also suitable for:

Dm 340