Input Switching To Hdmi And Rgb; Input Signal Screen Display - Hitachi UT32-MH700A User Manual

By pressing the Input Select button, you can switch the input to display
the image outputting from the external equipment connected to each
terminal (HDMI and RGB (/Composite)).
<From Remote Control>
Press the button on the remote control.
Each time this button is pressed, the screen displays the
corresponding mode in the following sequence.
HDMI
Press the or
<From Control panel>
The Input modes can also be switched using the Input Select button on the control panel.
Each time this button is pressed, the screen displays the corresponding
mode in the following sequence.
HDMI
Switching between RGB and Composite Input
NOTE
When pressing the
mode in advance if necessary.
1. Press the button in RGB or Composite mode.
2. Select "Setup" menu.
3. Select "RGB Input".
Select "Composite" to display the image from video output via the optional D-sub 15 pin - composite cable.
Select "RGB" to display the image from PC.
See and for details of "RGB Input" menu.
27 29
The input signal status can be displayed on the screen by pressing the
The display will go out in approximately 6 seconds.
HDMI mode
RGB mode
Composite
mode
RGB (/Composite)
button to directly select the input mode.
RGB (/Composite)
button, you will see the image from either RGB or Composite mode. You can set up the
H : 48.4kHz
V : 60.0 Hz
Composite
HDMI Input
Select button
RGB Input
Select button
Menu button
Input Select
button
button on the remote control.
Input mode
HDMI
*
DVI
720
Signal mode
* HDMI-DVI
connection only
Input mode
RGB
Input horizontal
frequency
Input vertical
frequency
Input mode
Input Select
Recall
button
20