Input Switching To Hdmi And Rgb; Input Signal Screen Display - Hitachi UT42X902 - 42" LCD Flat Panel Display Operating Manual

BASIC OPERATION (continued)

Input Switching to HDMI and RGB

By pressing the Input Select button
input to display the image outputting from the external equipment
connected to each terminal (HDMI and RGB (/Composite)).
<From Remote Control>
Press the button on the remote control.
Each time this button is pressed, the screen displays the
corresponding mode in the following sequence.
HDMI
Press the or
<From Control panel>
The Input modes can also be switched using the Input Select
button on the control panel.
Each time this button is pressed, the screen displays the
corresponding mode in the following sequence.
HDMI
Switching between RGB and Composite Mode
NOTE
When pressing button, you will see the image from either RGB or Composite mode. You can set up the
mode in advance if necessary.
1. Press MENU button in RGB or Composite mode.
2. Select "Setup" menu.
3. Select "RGB input".
Select "Composite" to display the image from a video source via the optional D-sub 15 pin - composite
cable.
Select "RGB" to display the image from PC.
See and for details of "RGB input" menu.
40 41

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the
The display will go out in approximately 6 seconds.
HDMI mode
RGB mode
Composite
mode
, you can switch the
RGB (/Composite)
button to directly select the input mode.
RGB (/Composite)
H : 48.4kHz
V : 60.0 Hz
Composite
Menu button
Input Select
button
RGB Input
Select button
HDMI Input
Select button
button on the remote control.
Input mode
HDMI
DVI *
Signal mode
720p
* HDMI-DVI
connection only
Input mode
RGB
Input horizontal
frequency
Input vertical
frequency
Input Select
INFO
button
24