Operating Instructions; Configuring The Starting Address; Dmx Operation; Master/Slave Mode (Sound-Active, Auto Mode) - Chauvet Obsession LED User Manual

4. O
PERATING

Configuring the Starting Address

DMX Operation

Master/Slave Mode (Sound-Active, Auto Mode)

4. Operating Instructions

I
NSTRUCTIONS
The Obsession™ LED fixture uses three DMX channels. The highest channel that the fixture may
be set to in order to function properly is 510. Any address higher than this will prevent access to
all of the channels.
If this is your first time using DMX, we recommend reading the "DMX Primer" section in the
"Appendix".
This is the operating mode which will allow for control with an external DMX controller. You must
set the starting address for this mode. If this is your first time using DMX, then it is recommended
that you refer to the "DMX Primer" section in the "Appendix" of this manual.
Mode
DMX
This mode allows a single unit to auto change in Standalone Mode.
Turn switch to the Slave position on the slave units, and they will react the same as the Master.
The Master must be set to standalone mode.
Mode
Slave
DIP switches
1~9 = set to the DMX starting address
10 = On
DIP switches
1, 10 = On
8 12/20/2010 2:38 PM