To Cancel Hot Desking; To Configure A New Time Zone On A Remote Ip Telephone; Configuring A New Time Zone On A Remote Ip Telephone - Nortel BCM50 Installation And Configuration Manual

58 Chapter 6 Global IP features

To cancel Hot Desking

You can cancel hot desking from either telephone.
1 Ensure that both telephones are on-hook before cancelling Hot Desking.
Note: There can be up to a 10-second delay after the call ends before the system will
enable you to cancel Hot Desking. This period can vary, depending on the call type.
2 Cancel the feature:
Diverted telephone: Press the display key under the
Live telephone:
a Access FEATURE *999.
b Press
CANCEL

Configuring a new time zone on a remote IP telephone

If the IP telephone connects to the system from a different time zone than the system, you can reset
the telephone so that it displays the correct local time.

To configure a new time zone on a remote IP telephone

1
At the telephone, enter FEATURE *510.
2
Press
CHANGE
3 Press * to toggle between + and - (minus), depending on which side of the time zone the
telephone is located. Generally, west is minus (-); east is plus (+)
4
Enter the number of hours difference.
5 Press .
OK
Offset time zones: For areas, such as Newfoundland, Canada, where the time zone is offset from a
full hour, press the # key to add 0.5 to the number of hours, then press
Note: The telephone is still configured to change when Daylight Savings Time
occurs if the host system is programmed to change. Therefore, if the telephone is
in an area that does not change time, for example, Saskatchewan, Canada, must
readjust the time on your IP telephone at each time change. You also must
readjust the time if the IP telephone is in a time zone that changes and the system
is not, for example, if the telephone is in Alberta, Canada and the system is
located in the business headquarters in Saskatchewan.
N0027269 01 N0027269 01
.
.
prompt.
CANCEL
.
OK