Table of Contents
Advertisement
Linux Driver Support
1 – SuSE Linux Enterprise Server (SLES) installation
Overview
This section provides instructions describing how to install and utilize the
RocketRAID 174x Adapter on a SuSE (SLES) Linux system.
2 - Installing SLES Linux on the RocketRAID 174x
Host Adapter
Note: If the OS is running kernel that differs from the one supported by the
precompiled driver, the precompiled drivers cannot be used. A driver can be built for
this kernel using the OpenSource package for the RocketRAID 174x controller. This
package is available from our website, and is posted on the BIOS/Driver page for the
RocketRAID 174x.
To install SLES onto hard disks or RAID arrays attached to RocketRAID 174x
controller, follow the steps outlined below:
Step 1 Prepare the Driver Diskette
The driver is contained in a floppy diskette image file (slesdd.img).
On a DOS or Windows system, a driver diskette can be generated using rawrite.exe.
This utility is included on the SLES Linux CD (under /dosutils). Run rawrite using a
command prompt window, and follow the directions it provides.
On a Linux system, use the "dd" command to generate a boot diskette. Insert a
floppy disk into the floppy drive and type the following command:
# dd if=SLESdd.img of=/dev/fd0
Step 2 Install SLES Linux
1.
Start the install procedure by booting from SLES installation CD.
2.
After the CD boots, select the "Installation" option and press F6 to load the
driver.
3.
Insert the Driver Diskette when it displays "Please insert the Driver Update
floppy".
5-9
Hide quick links:
Advertisement
Table of Contents
