Menu Bar - Sanyo PLC-XM100 Owner's Manual

Basic Operation
For detailed functions of each menu, see "Menu Tree" on pages 73-75.
Main Menu
Input
Used to select an input source (Input 1, Input 2, Input 3 or Network) (p.33).
Note: Network will be not displayed when optional PJ-Net Organizer is not attached.
PC adjust
Used to adjust the parameters to match with the input signal format (pp.37-39).
Image select
For computer source, used to select an image level among Standard, Real, and Image 1-10 (p.40).
For Video source, used to select an image level among Standard, Cinema, and Image 1-10 (p.46).
Image adjust
For computer source, used to adjust the computer image. [Contrast/Brightness/Color temp./White balance (R/G/B)/
Offset(R/G/B)/Sharpness/Gamma/Reset/Store] (pp.41-42).
For Video source, used to adjust the video image. [Contrast/Brightness/Color/Tint/Color temp./White balance (R/G/
B)/Offset (R/G/B)/Sharpness/Gamma/Noise Reduction/Progressive/Reset/Store] (pp.47-48).
Screen
For computer source, used to adjust the size of the image. [Normal/True/Wide/Full/Custom/Digital zoom +/-/Keystone/
Ceiling/Rear/Reset] (pp.42-44).
For Video source, used to adjust the size of the image. [Normal/Wide/Custom/Keystone/Ceiling/Rear/Reset] (pp. 49-
50).
Sound
Used to adjust the volume or mute the sound (p.28).
Setting
Used to set the projector's operating configurations (pp.51-62).
Information
Display the input source information: Input, H-sync freq., V-sync freq., Screen, Language, Lamp status, Lamp counter,
Filter counter, Power management, Key lock, PIN code lock, Shutter management, Simple mode, Remote control,
and SERIAL NO. (p.29).
Network
See the owner's manual of "Network Set-up and Operation".
Guide
The key operation is displayed.
26

Menu Bar

Sub-Menu