Sanyo PLC-XM100 Owner's Manual page 78

Appendix
The projector is detecting abnormal condition.
Indicators
WARNING
POWER LAMP
TEMP.
green red
Fig.2 Filter replacement icon
Fig.3
Fig.4 Filter cartridge replacement icon
78
WARNING
SHUTTER
FILTER REPLACE
blue
red orange
Projector Condition
LAMP
orange
If the Filter counter reached a time set in the timer setting, a Filter
replacement icon (Fig.2) appears on the screen and the WARNING
FILTER indicator on the top panel lights up. Replace the filter as
soon as possible. If the filter is out of scroll and the projector reaches
a time set in the timer setting, Fig. 3 appears on the screen and the
WARNING FILTER indicator lights up. Replace the filter cartridge as
soon as possible.
If the filter is clogged and no scroll is left in the filter cartridge, a Filter
cartridge replacement icon (Fig.4) appears on the screen and the
WARNING FILTER indicator lights up. Replace the filter cartridge as
soon as possible.
Note:
Fig.2, Fig.3 and Fig.4 icon will not appear when the Display function is
set to Off (p.52) or during "Freeze" (p.30).
The filter cartridge is not installed in the projector. Check the filter
compartment to see if the filter cartridge is installed in the projector.
When the filter cartridge is installed and the indicators continue to
light and blink, read the column below.
The projector detects an abnormal condition and cannot be turned
on. Unplug the AC power cord and plug it again to turn on the
projector. If the projector is turned off again, unplug the AC power
cord and contact the dealer or the service center. Do not leave the
projector on. It may cause an electric shock or a fire hazard.
The shutter is out of control.
The shutter is out of control. (The projector is in the cooling mode.)
The shutter is out of control. (The projector is in the stand-by mode.)
In that case, contact the service station immediately.