Sanyo PLC-XM100 Owner's Manual page 71

appears on the screen
The image is out of focus.
The image is not bright
enough.
The color is strange.
The image is Left/Right
reversed.
The image is Top/Bottom
reversed.
The image is distorted or
runs off.
Auto PC adjustment
function does not work.
Some displays are not
seen during the operation.
The setting does not
remain after turning off
power.
Power management
function does not work.
Image disappears
automatically.
Capture function does not
work.
Some menus cannot be
selected.
No sound
– Filter is out of scroll. Replace the filter cartridge with a new one promptly. (See pages
64-65)
– Adjust the focus of the projector.
– Check Projection Lens to see if it needs cleaning.
Note: Moving the projector from a cool temperature location to a warm temperature
location may result in moisture condensation on Projection Lens. In such
cases, leave the projector OFF and wait until condensation evaporates.
– Projecting from excessive slant angle to the screen may cause keystone distortion
and partial imperfect focus.
– Make sure the projection screen is at least 4.3' (1.3 m) away from the projector.
– Check if Contrast or Brightness is adjusted properly. (See pages 41, 47)
– Check if Image level is selected properly. (See pages 40, 46)
– Check the Lamp control function. ( See "Setting" section on page 55)
– Check the LAMP REPLACE indicator. If it lights, the end of lamp life is approaching.
Replace the lamp with a new one promptly. (See page 66)
– Check the Input signal, color system, video system, or computer system mode.
– Adjust the Image Level properly. (See pages 40, 46)
– Check the Ceiling / Rear function. (See pages 44, 50)
– Check the Ceiling function. (See pages 44, 50)
– Check PC adjust Menu or Screen Menu and adjust them.
– Check the Input signal. Auto PC Adjustment function cannot work when 480p, 575p,
720p, 480i, 575i, 1035i, or 1080i is selected or when the digital signal is input into
DVI terminal. (See page 37)
– Check the Display function. (see page 52)
– Make sure you selected Store after adjusting settings. Some settings cannot be
stored if not registered with Store function.
– Power management function cannot work while Freeze function is running or the
shutter is closed.
– Check the power management function in the Setting. The power management is set
to On at the factory.
– Check the connection to see if there is signal.
– Each of the Video Input and Computer Input has a limit on selectable menus.
– Check the audio cable connection from audio input source.
– Adjust the audio source.
– Press the Volume + button. ( See page 28)
– Press the Mute button. (See page 28)
– Is the image projected? You will hear the sound only when the image is projected.
– Check the Build-in SP function. (See page 28)
Appendix
71