Basic Operation - Tripp Lite SMARTINT2200VS Owner's Manual

200404080 932245 SMARTINT22003000VS OM.qxd
Optional Installation
4 EPO Port Connection
This optional feature is only for those applica-
tions which require connection to a facility's
Emergency Power Off (EPO) circuit. When the
UPS is connected to this circuit, it enables emer-
gency shutdown of the UPS's inverter.
Using the cable provided, connect the EPO port of
your UPS (see
closed or normally open switch according to the
circuit diagram (see
phone line surge suppressor; do not connect a
phone line to this port.

Basic Operation

Buttons
) to a user-supplied normally
4a
). The EPO port is not a
4b
"ON/OFF/STANDBY" Button
• To turn the UPS ON: with the UPS plugged into a live AC wall outlet,*
press and hold the ON/OFF/STANDBY button for one second.**
Release the button. If utility power is absent, you can "cold-start" the UPS
(i.e.: turn it ON and supply power for a limited time from its batteries***)
by pressing and holding the ON/OFF/STANDBY button for one second.**
• To turn the UPS OFF: with the UPS ON and receiving utility
power, press and hold the ON/OFF/STANDBY button for one sec-
ond.** Then unplug the UPS from the wall outlet. The UPS will be
completely OFF.
* After you plug the UPS into a live AC outlet, the UPS (in "Standby" mode) will auto-
matically charge its batteries, but will not supply power to its outlets until it is turned ON.
** The alarm will beep once briefly after the indicated interval has passed. *** If fully
charged.
5
5/26/2004 4:26 PM Page 5
4a
OPTION 1: USER SUPPLIED NORMALLY CLOSED SWITCH
5
4
RJ11
3
PLUG
2
NO CONNECTION
OPTION 2: USER SUPPLIED NORMALLY OPEN SWITCH
5
4
RJ11
3
PLUG
NO CONNECTION
2
4b
4-5 JUMPER
N.C. EPO SWITCH
N.O. EPO SWITCH