Connect A Bar Code Reader; Step 6: Connect The Terminal Power Pack; Bar Code Reader Connection - VeriFone Omni 3200 Reference Manual

Omni 3200 Reference Manual

Connect a Bar Code Reader

Step 6: Connect the Terminal Power Pack

14
To connect a VeriFone bar code reader, or wand, insert the RJ45-type
plug on the end of the cable into the 'Bar Code/PINpad' serial port on
the back panel of the terminal (see Figure 13).
Figure 13 Bar Code Reader Connection
Warning: Do not plug the power pack into an outdoor outlet or
operate the terminal outdoors. Also, disconnecting the power source
during transaction processing may cause data files stored in the
terminal memory to be lost.
To connect the Omni 3200 terminal to a power source:
1. Insert the barrel-shaped connector on the end of one
power pack cable into the round power port on the
back panel of the terminal (see Figure 14). The power
port is identified by the 'electrical power' icon, shown
to the right.
Step 6: Connect the Terminal Power Pack