Cable Connection For Terminal-To-Terminal Uploads; Terminal-To-Terminal Cable Connection - VeriFone Omni 3200 Reference Manual

Omni 3200 Reference Manual

Cable Connection for Terminal-to-Terminal Uploads

66
To upload an application or an operating system version from one
Omni 3200 terminal to another, you must use a serial cable to connect
the 'RS232' ports of the sending and receiving terminal. See Figure
18 below.
The cable that is available for this purpose (VeriFone part number
05651-XX) has a 10-pin RJ45-type modular connector on each end.
You insert the connector into the RS232 serial port on the back panel
of each terminal.
To connect the sending and receiving Omni 3200 terminal for a
terminal-to-terminal upload:
1. Disconnect the power source from both terminals.
2. Insert the RJ45-type modular connector on one end of the
download cable into the 'RS232' port on the back panel of the
sending terminal.
3. Insert the RJ45-type connector on the other end of the cable into
the 'RS232' port on the back panel of the receiving terminal.
4. Connect the power source to both terminals.
Figure 18 Terminal-to-Terminal Cable Connection
Setting Up the Download Environment