Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ozito HGN-2100
Summary of Contents for Ozito HGN-2100
- Page 1 WHAT’S IN THE BOX HEAT GUN 2000W Heat Gun INSTRUCTION MANUAL SPECIFICATIONS Power: 2000W Input: 230-240V~50Hz Airflow: Fan Setting 1: 250 l/min Nozzles x 4 Fan Setting 2: 500 l/min Temperature Control: Variable (50-450º/90-600º) Weight: 0.81kg ozito.com.au Scrapers x 2 HGN-2100...
- Page 2 SETUP & PREPARATION KNOW YOUR PRODUCT HEAT GUN 1. ASSEMBLY 1 Heating Element 4 Sure Grip Handle 2 2 Speed On/off Switch 5 Flat Base Stand Nozzles 3 Temperature Control Dial 1. Push the open end of the nozzle onto the heat gun. Scraper 1.
- Page 3 OPERATION 2. CONTROLS 3. OPERATING THE HEAT GUN The tool is recommended for use with a residual current Note: Ensure the heat gun is in the off position ‘0’ before device with a rated residual current of 30mA or less. conecting to a power supply.
- Page 4 Defrosting Water Pipes 1. Fit the glass protector 2. Heat the surface until the nozzle. paint blisters. 1. F it the reflector nozzle. 2. Heat frozen area inwards, from the edge to the centre. 2. Remove paint with the corner scraper. HGN-2100...
- Page 5 SPARE PARTS Switch SPHGN2100-18 For spare parts visit www.ozito.com.au Or contact Ozito customer service Australia 1800 069 486 New Zealand 0508 069 486 E-mail: enquires@ozito.com.au MAINTENANCE • K eep the ventilation vents of the heat gun clean at all times, if possible, prevent foreign matter from entering the vents. • A fter each use, blow air through the heat gun housing to ensure it is free from all dust particles which may build up. Build up of dust particles may cause the heat gun to overheat and fail.
- Page 6 Tool: 2000W Heat Gun SPARE PARTS Model No. HGN-2100 The following is a list of spare parts carried by Ozito. Please contact Customer Service for any parts not listed. Item Item Description Part No. Description Part No. 18 Power Switch...
- Page 7 Always use an approved extension lead suitable for the power input of this tool. Before use, inspect corresponds to the voltage on the rating plate. the extension lead for signs of damage, wear and ageing. Replace the extension lead if damaged Note: The supply of 230V and 240V on Ozito tools are interchangeable for Australia and New or defective. Zealand. When using an extension lead on a reel, always unwind the lead completely. Use of an extension lead not suitable for the power input of the tool or which is damaged or defective may result in a risk This tool is double insulated in accordance with AS/NZS 60335-1;...
- Page 8 • Failure to perform maintenance as set out within the instruction manual. • If the tool is disassembled or tampered with in any way. • Professional, industrial or high frequency use. OZITO Australia/New Zealand (Head Office) 1-23 Letcon Drive, Bangholme, Victoria, Australia 3175. 0313...
Need help?
Do you have a question about the HGN-2100 and is the answer not in the manual?
Questions and answers