Troubleshooting - HAMPTON BAY M313 series Use And Care Manual

Troubleshooting

PROBLEM
There is no power and the logs do not
glow.
The logs glow but there is no flame ef-
fect.
The power cord gets warm.
The heater does not blow warm air.
The heater does not work, but Power and
Heater settings are "ON" and the
thermostat is set.
The flame effect works but the heater
function does not and the ember bed
flashes when the Heater button is
pressed.
The remote control is not working.
POSSIBLE CAUSE
There is no power to the unit.
The flame effect turned off.
This is normal operation.
The thermostat setting is preventing the heater
from turning on.
Manual reset overheat protection
triggered.
The heater is disabled.
There are no batteries or the signal is poor.
16
CORRECTIVE ACTION
Check that the unit is plugged into a
standard 120V outlet. Press the Power button
several times, make sure power is set to the
"ON"position.
Press the Flame button several times.
Check your heater cord and plug
connections. Faulty wall outlet connections
or loose plugs can cause the outlet or plug
to overheat. Be sure the plug fits tight in the
outlet. Heaters draw more current than small
appliances, overheating of the outlet may
occur even if it has not occurred with the
use of other appliances. During use check
frequently to determine if your plug outlet or
faceplate is HOT! If so, discontinue use of the
heater and have a qualified electrician check
and/or replace the faulty outlet(s).
Adjust the temperature settings to ensure
that the thermostat is set higher than the
current room temperature.
Turn the Power to "OFF" and unplug the unit
from the wall outlet for 5 minutes. After 5
minutes plug the unit back into the wall out-
let, and operate as normal. If the problem
persists contact customer service.
With the power on press and hold the Power
button on the control panel for 10 seconds.
Once re-enabled the ember bed lights will
flash multiple times.
Change the remote batteries.
Operate the remote control at a slow meas-
ured pace. Press the remote control buttons
with an even motion and gentle pressure.
Repeatedly pressing buttons in rapid
succession may cause the transmitter to
malfunction.